Drill press squeak fixed!

TurningChuck9818I think since the day I got it several years ago, my drill press has squeaked.  It happened – every time – when I turned the chuck by hand a little to orient the hole for the chuck key to a convenient place.  It’s fine when it’s running.

I couldn’t tell where it was coming from, but have tried a couple of times to make it stop – to no avail.  When it annoyed me today, I finally caught it.

I pulled the belt off the speed change pulleys, and (like always) turned the quill pulley by hand.  No noise.  But this time I turned the motor – and it squeaked!  Wow – it’s narrowed down!

But what’s squeaking?  I dribbled a little oil into the top bearing – no change.  Looking through the cooling slots near the bottom of the motor, I could see a mechanism – which turned out to be the centrifugal switch on this single phase motor – and that seemed the likely culprit.  I was temped to just spray some oil all over it, but I didn’t understand how it worked, and didn’t want oil on the actual contacts.

Google images provided lots of pictures, but none looked quite like mine.  Then I looked through the slots on the other side of the motor – and there were electrical contacts!  Now if I could see what was rubbing, I could lube it without getting oil on the contacts.

I finally divined that a disc was rubbing against a protrusion on the contact mechanism.  OiledSwitchActuator9815This was by design – it’s how the contact is operated.  I put a drop of oil on the end of a long scribe, carefully inserted it through a cooling slot and deposited the payload pretty accurately right where the disc and protrusion met.  I spun the motor back and forth a few times – and the squeak was gone!  The arrow points to a bit of shininess that’s probably oil at the critical spot.

That’s been bugging me for years.  Now the fix will come back and give me a little pleasure every time I use the drill press.  Excellent.

This entry was posted in Home Repair. Bookmark the permalink.

8 Responses to Drill press squeak fixed!

  1. Rob Shepard says:

    Thanks, your suggestion took care of the squeak in my Craftsman drill press.

  2. Thomas Teske says:

    “The Squeak” started a few days ago on my new Wen drill press and has been driving me nuts. One drop of oil and magically gone. Thanks for the holiday gift!

  3. Lee says:

    Wow this may be an older post but since I just bought this same drill press used yesterday, I heard the same noise. Found this fix, did the same, and it’s silent! Happy new year, 2021!

  4. JJ says:

    Wow, thank you!!
    I have a different Jet drill press with the same problem except on mine it’s impossible to see the plate through vents. I was able to locate it thanks to your photo and fix the problem without disassembling the motor. Thanks again!

Leave a Reply to Rob Shepard Cancel reply

Your email address will not be published. Required fields are marked *